Air

CRYSTAL Airä Model DV-1 115V/60Hz

Now you can enjoy more precise dentistry with more options than ever before. The air abrasion system combines a finely controlled high pressure air stream with a highly adjustable 27micron aluminum oxide powder flow. We have designed our system with the demanding clinician in mind. When deciding on purchasing an air abrasion system, you must look for the system that allows you the most control. This capacity for control begins with our unique Ultralow ™ mode of operation.

UltraLow ™ the Intelligent decision.

Our CrystalAir ™ unique Ultralow™ feature allows you to treat deeper into dentin without the use of anesthesia. This unique operating mode centers around the removal of dentin at very low pressures.....down as low as 20 PSI. Very low air pressures generate no patient sensitivity. Our equipment removes tooth structure at these very low air pressures.

Independent adjustment of air pressure and powder flow allows for more visibility, control and patient comfort with less powder usage. This flexibility and control allows the dentist to treat the entire range of cavity design categories, it allows the dentist to remove composite and sealants selectively and to do a myriad of peripherally associated functions. These range from porcelain repair, casting and crown clean up, cement and stain removal to the extremely important caries diagnostic procedure.

All in all, the CrystalAir ™ air abrasion cavity preparation device is THE cutting-edge and latest word in total and complete control, reliability and user friendliness.

Specifications:

Power Requirements: 115 volt, 60 hz, 1 amp or 230 volt, 50 hz, .5 amp
Air Requirements: Clean, dry, 40 psi minimum, -- 125 psi maximum 1.5 cfm @ 80 psi
(276 kPa min. -- 862 kPa max. 42L3/m at 552 kPa)
Standard Dimensions: 13" W x 11" D x 11" H (33cm W x 28cm D x 28 cm H)
Operating Pressures: 5 psi minimum -- 140 psi maximum

Condition - New

Our Price - $5,350


11 REASONS WHY THE CRYSTALAir ™ IS THE BEST AIR ABRASION UNIT!

(We just couldn’t do it in 10!)
1. Heliablate ä will cut through enamel and prep dentin twice as fast as any other air abrasion device, (or laser!) with no sacrifice to patient comfort.
2. DUAL MODES - Air Abrasion and Helium Ablation.
3. UltraLow ® AIR PRESSURE: 30 or 40 psi to insure maximum patient comfort and ultimate control when used on extensive preps in dentin. Also ideal for sealant and diagnostic procedures.
4. IINDEPENDENT POWDER FLOW ADJUSTMENT: assures optimum powder to air ratio for all nozzle tip diameters.
5. NO NOZZLE PLUGGIING – EVER, even with the smallest tips.
6. NO MESS: CRYSTALAir uses 1/10th the abrasive of other units, resulting in cleaner operatories, greater visibility, and more control.
7. SIX color-coded nozzle diameters at 45º and 90º angles for optimum versatility also available in hook style tips.
8. ARTIICULATIING HANDPIIECE to adjust nozzle angle 15º in any direction for optimum intraoral positioning of the abrasive jet.
9. AIIR ABRASIION RESIISTANT MIIRROR that will not frost from abrasive overspray.
10. State of the art, no maintenance air dryer makes use of the existing facility compressor possible without concerns for moisture contamination.
11. Easy preventative maintenance and service routines and a 3-year warranty make the CRYSTALAir the standard for quality and reliability.
Need more reasons or information?